Shop Vac 9032800 Ridgid Replacement Cartridge

Even the best vacuum cleaners in the world will in the long run need galore alternate parts. Fortunately for you, Kirby has made the constituents available that you made need to replace each few years on your Kirby Cleaning System.

Kirby Brush Rolls

You will normally need to get this substituted each 2 or 3 years. Once you have had your system for 24 months or longer, you will want to commence to check to make sure that the brush roll is rigid and that there is no debris caught up in the bristles. If you find that it has lost it is rigidity, it is time to replace it and get a new one. If you have a brush roll that is not functioning properly, your Kirby cleaner will not be performing at it is most eminent level.

The Kirby Belt

The belt on the brush roll will finally wear out from neverending use. When this happens, you will need to get a alternate Kirby Belt. Deterioration is easy to spot as the belt will be evidently worn and or frayed. Again, a bad belt will hinder the performance of your vacuum and you will want to replace a bad belt immediately.

Other Kirby Accessories

Kirby Cleaners commonly come with a fantasti supply of extra attachments, but you may find that you need a longer hose, power cord or a dissimilar type of attachment that is queer to your cleaning interest. Have no fear because Kirby comes through in flying colors once again with a finish line of distinguishing trait attachments.

There is no better cleaning scheme available than what Kirby Home Care Products offers. You will not find a company that has the dedication to quality that Kirby shows in everything they do. From their cleaning schemes to their carpet cleaning bags to their accessories, you will not find a better line of merchandise available for your floor care needs.

Shop Vac 9032800 Ridgid Replacement Cartridge Picture

Shop Vac 9032800 Ridgid Replacement Cartridge Image

Shop Vac 9032800 Ridgid Replacement Cartridge Photo

Shop Vac 9032800 Ridgid Replacement Cartridge Picture

Most helpful client reviews

9 of 10 people found the following review helpful.
Great alternate filter for Craftsman shop-vac
By Michael J. Rumberger
As per an earlier review, I too have a 16 gallon Craftsman shop vac that utilizes a “red-stripe” filter. The vac is with regards to 2 + years old so I was probably due for new filter. Even though the measurements of this substitute filter are somewhat dissimilar than the Craftsman introductory filter, this substitute fit just fine, but did require that I use the primary cap from the old filter rather of the one provided so it could be secured the the suitable filter emplacement on the vacuum. No problem – it fit just fine. I am very happy with this product and would unquestionably buy one again versus paying an outrageous amount to buy one from Sears.

6 of 7 people found the following review helpful.
NOT SIZE IT SAYS……
By Dan Briggs
This is NOT 7×7, it is 7 x 8 1/2 and no center hole in the bottom plate. Be careful this doesn’t fit the vacs they say it does……..

6 of 7 humans found the following review helpful.
Fit perfectly
By David G. Thomas
This fits “OLDER” model Ridgid Vac’s ( circa 1999). I had a hard time finding one locally so I checked Amazon and happened throughout this filter. Perfect fit.

I have noticed most folks that give negative reviews actually don’t do the proper exploration to in truth comprehend what they are buying and end up blaming the web site or vendor for their own ignorance.

See all 31 client reviews…